Polaris Vrx iQ+ Owners Manual
Find everything you need to know from installation and maintenance to troubleshooting for your Polaris Vrx iQ+.
I have problems with my Polaris Vrx iQ+ Error Codes for Polaris Vrx iQ+ polaris-vrx-iq-plus-owners-manualPolaris Vrx iQ+ User Manual PDF Summary
I have problems with my Polaris Vrx iQ+What Should i Do if My Polaris Vrx iQ+ Stopped Working?
I have problems with my Polaris Vrx iQ+How to Use the Polaris Vrx iQ+ Polaris Pool Cleaner
I have problems with my Polaris Vrx iQ+Polaris Vrx iQ+ Frequently Asked Questions
I have problems with my Polaris Vrx iQ+Polaris Vrx iQ+ Replacement Parts
Polaris Vrx iQ+ Help
Need help resolving issues with your Polaris Pool Cleaner? Post your Question Below.
Power on them turns off 10 seconds later
Front Cleaning Wheel/Brushes not spinning
My robot is not turning on
I have a Polaris Vrx IQ+ that needs to have the swivel cable replaced. The recommended replacement cable, (PTS-R0726700) has a single connector. When I took the Polaris cleaner apart to replace the swivel cable, it actually has a splitter and has two connections inside the shell. Did Polaris change swivel cables in the last few years? My Polaris Vrx IQ is 3 years old. Thank you.
The brush rollers are not turning. I believe the teeth on gears have been worn down or broken up even though I have not had it that long can I order the part or can you send Me the shaft with the gears on it at the rollers are on?
The lift system fails to engage when button is pressed on the controller or the phone app.
Suddenly, my Vrx iQ+ seems to have a power issue. the panel turns on, but when i actually place the robot in the water and turn on… it immediately kicks off the control panel. from my limited knowledge.. it sounds like a power cable issue perhaps? are there fuses? any ideas?
thanks in advance
Ron Quillen
The left wheels and brush are not turning while the VRX iQ+ unit is running. How do I fix this?
My VR IQ is only going back and forth and not cleaning the pool. The time on the base is not moving but no error codes
We have used our Polaris VRX iQ+ perhaps THREE Times.
The control box keeps separating from the carrier when moving to the pool.
We took it to Leslie’s, they put it back on.
Within MINUTES of returning home,
when VERY CAREFULLY
and VERY LIGHTLY lifting it about two inches over the transom,
the control box SEPARATED AGAIN.
For an almost $2,000 purchase, this is unacceptable.
Not sure if we got a bad one,
or if it is a horrible design.
This should NOT be happening.
The VRXiQ snaps in pretty hard. Mine is solid in the caddy with no issues of falling out. Is it possible the controller cradle was damaged upon controller installation? Did it snap into the cradle solid. Or is it just laying on top?