The Dyson DC33 emptying the clear bin
Caution:
- Switch ‘OFF’ the vacuum and unplug it before emptying the clear bin.
- Empty as soon as the dirt reaches the level of the MAX mark – do not overfill.
- To remove the clear bin from the vacuum, press the button at the rear of the cyclone carrying handle. To release the dirt, press the red bin release button. Emptying into a bag is recommended for allergy sufferers.
- Do not use the vacuum without the clear bin in place.
- To minimize dust/allergen contact when emptying, encase the clear bin tightly in a plastic bag and empty it. Remove the clear bin carefully and seal the bag tightly, dispose as normal.
The Dyson DC33 cleaning the clear bin
Caution:
- To remove the cyclone unit from the clear bin press the red bin release button. This exposes a small silver button behind the red opening mechanism. Press the silver button and separate the cyclone unit from the clear bin.
- Ensure the clear bin is completely dry before replacing it.
- PLEASE NOTE:
- Do not use detergents, polishes, or air fresheners to clean the clear bin.
- Do not put the clear bin in the dishwasher.
- Clean the shroud with a cloth or dry brush to remove lint and dust
The Dyson DC33 washing your filter
Caution:
- Switch ‘OFF’ and unplug the vacuum before removing the filters.
- Ensure filters are completely dry before refitting to the vacuum.
- PLEASE NOTE:
- This machine has two filters, located as shown. It is important to check your
filters regularly and wash at least every 3 months according to instructions, to
maintain performance. Filter B should be rinsed and tapped out until the water
runs clean, then tapped out again to ensure all excess water is removed. This
will normally require up to 10 rinse cycles.
- This machine has two filters, located as shown. It is important to check your
- After washing please leave for 24 hours to dry completely.
- The filters may require more frequent washing if vacuuming fine dust.
- Do not use detergents to clean the filters.
- Do not put the filters in a dishwasher, washing machine, tumble dryer, oven, microwave, or near a naked flame
The Dyson DC33 Looking for blockages
Caution:
- Switch ‘OFF’ and unplug the vacuum before checking for blockages. Failure to do so could result in personal injury.
- Please ensure the vacuum is upright and switched off before removing the hose or airway inspection parts.
- Beware of sharp objects when clearing blockages.
- Refit all parts of the vacuum securely before using it.
- PLEASE NOTE:
- Clearing blockages is not covered by your vacuum’s limited guarantee.
- This vacuum is fitted with an automatically resetting thermal cut-out. If any part of the vacuum becomes blocked, it may overheat and automatically cut out. Switch ‘OFF’ and unplug the vacuum and leave to cool down for 1-2 hours before checking the filter or for blockages
The Dyson DC33 clearing brush bar obstructions
Caution:
- Switch ‘OFF’ and unplug the vacuum before clearing brush bar obstructions. Failure to do so could result in personal injury.
- Beware of sharp objects when clearing obstructions.
- Refit all parts of the vacuum securely before using it.
- PLEASE NOTE:
- Clearing brush bar obstructions is not covered by your vacuum’s limited guarantee
The Dyson DC33 brush bar troubleshooting
Caution:
- Ensure the machine is in the reclined position.
- Ensure the clutch is turned on (See page 5).
- Check the cleaner head for blockages (i.e. tangled hair, large debris).
- If the brush bar still isn’t spinning, contact a Dyson expert at 1-866-277-4649
Motor won’t run-changed switch but didn’t help