Dyson Cyclone V10 Absolute Troubleshooting, & Problems

Caution:

Empty as soon as the dirt reaches the level of the MAX mark – do not overfill.
Ensure the machine is disconnected from the charger before emptying the clear bin. Be careful not to pull the “ON” trigger.
Avoid pulling the “ON” trigger when emptying.
Remove the wand by pressing the red wand release button and pulling away from the bin.
To release the dirt:
– Hold the machine with the bin in a downward position.
– Firmly push the red bin release button.
– The bin will slide down, cleaning the shroud as it goes.
– The bin base will then open.
– The bin base will not open if the red button is not pushed down fully.
To minimize dust/allergen contact when emptying, encase the clear bin tightly in a plastic bag and empty it.
Remove the clear bin carefully from the bag.
Seal the bag tightly, and dispose as normal.

Caution:

If it is necessary to clean the clear bin:
Follow the instructions in the “Emptying the clear bin” section.
Press the red button located on the bin runner to release the bin and slide the bin off the runner.
Clean the clear bin with a damp cloth only.
Ensure that the clear bin and seals are completely dry before replacing them.
To refit the clear bin:
– Insert the spine onto the bin runner.
Close the clear bin by pushing the bin base upwards until the clear bin and bin base click into place.
The clear bin is not dishwasher safe and the use of detergents, polishes, or air fresheners to clean the clear bin is not recommended as this may damage your machine.

Caution:

Your machine has two indicator lights that will help alert you that simple maintenance steps are needed.
The filter indicator will flash intermittently when the filter unit is not fitted correctly. Follow the instructions on how to refit the filter unit in the ‘Washing the filter unit’ section.
The filter indicator will light continuously when the filter unit needs washing. Follow the instructions on how to wash the filter unit in the ‘Washing the filter unit’ section.
The blockage Indicator LED will light if there is a blockage. Follow the instructions on how to clear blockages in the ‘Looking for blockages’ section

Caution:

Check and wash the filter unit, according to the instructions, to maintain performance.
- Remove the filter unit by twisting it counterclockwise to the open position. Gently pull away from the machine.
- Wash the inside of the filter unit first; hold it upright under the cold water tap and agitate using a rotating motion.
- Wash the outside of the filter unit; fill the unit with cold water, place your hand over the open end, and shake gently.
- Repeat washing the inside and outside of the filter unit until the water runs clear.
- Gently tap the filter unit to remove any excess water and leave it to dry with the filter end down.
- Leave the filter unit to dry completely for a minimum of 24 hours.
- Check that the filter unit is completely dry.
- To refit, return the filter unit to the open position and twist it clockwise until it clicks into place.
The filter unit may require more frequent washing if vacuuming fine dust or using mainly maximum suction.
Do not put the filter unit in a dishwasher, washing machine, tumble dryer, oven, microwave, or near a naked flame.

Caution:

This machine is fitted with an automatic cut-out.
If any part becomes blocked the machine may automatically cut out.
This will happen after the motor pulses a number of times (i.e switches on and off in quick succession) and the blockage indicator LED will illuminate.
Leave to cool down before looking for blockages.
Ensure the machine is disconnected from the charger before looking for blockages. Failure to do so could result in personal injury.
Clear any blockage before restarting.
Refit all parts securely before using.
Clearing blockages is not covered by your warranty

Caution:

LEDS INDICATOR	MEANING
	Battery fault – call the Dyson Helpline
	Main body fault – call Dyson Helpline
	Charger fault – call the Dyson Helpline