Ariens Crossover 932050 Troubleshooting

If you are having problems with your Ariens Crossover 932050 Snow Blower, you are not alone. Many Ariens Crossover 932050 owners experience issues with their snow blower from time to time, and it can be frustrating to deal with these problems.

I have problems with my Ariens Crossover 932050

Ariens Crossover 932050 Snow Blower Problems

Below are common issues and solutions for the Ariens Crossover 932050:

The Ariens Crossover 932050 Engine will not start

Cause Solution
  • Engine switch is in stop position
  • Push the switch to the on position. See Engine Key and Run / Stop Switch on page 9.
  • Engine key is not in unit.
  • Insert key. See Engine Key and Run / Stop Switch on page 9.
  • Choke is off
  • Turn choke cont rol knob to on position. See Choke Control Knob on page 9.
  • Fuel valve is closed
  • Open fuel valve. See Primer Bulb on page 9
  • Fuel tank is empty
  • Fill fuel tank with fuel. See Before Operating Unit on page 10.
  • Cord not plugged in (electric start models only)
  • Plug power cord in or replace worn cord. Reset circuit breaker
  • Engine is not primed
  • If engine is cold, press primer bulb three times and start engine. Do not prime a warm engine. See Primer Bulb on page 9.
  • Spark plug wire is disconnected
  • Connect spark plug. Refer to engine manual
  • Faulty spark plug
  • Replace spark plug
  • Excessive fuel in engine cylinder (flooded)
  • Turn choke control knob to off position and reattempt starting. See Start Engine on page 10.
  • Engine is faulty
  • See your Ariens dealer or authorized engine manufacturer’s service center.

The Ariens Crossover 932050 Engine starts hard or runs poorly

Cause Solution
  • Fuel mixture too rich
  • Turn choke control knob to off position. See Choke Control Knob on page 9.
  • Spark plug is faulty, fouled, or incorrectly gapped
  • Clean and correctly set spark plug gap (refer to engine manual) or see your Ariens dealer
  • Fuel cap vent is blocked.
  • Install new fuel cap

The Ariens Crossover 932050 Excessive vibration

Cause Solution
  • Loose parts or damaged auger paddles
  • Stop engine immediately. Replace auger paddles. See Replace Auger Paddles on page 16 or see your Ariens dealer

The Ariens Crossover 932050 Unit does not throw snow or throws it poorly

Cause Solution
  • Impeller is frozen in place
  • Move unit to a warm place to thaw
  • Ice or debris is obstructing auger
  • Stop engine and wait for all moving parts to stop and for hot parts to cool. Check for an remove obstruction before restarting
  • Discharge chute is clogged with snow
  • Stop engine and wait for all moving parts to stop and for hot parts to cool. Clean discharge chute and auger housing with clean-out tool. DO NOT use your hands.
  • Auger drive belt is slipping, worn or damaged
  • Adjust or replace auger drive belt. Refer to the service manual for your unit.

The Ariens Crossover 932050 Excessive snow is left behind.

Cause Solution
  • Scraper blade is worn or damaged
  • Adjust when worn and replace when damaged or when blade has been adjusted down as far as possible and does not touch ground or clear correctly. See Replace Scraper Blade on page 17.

The Ariens Crossover 932050 Snow does not discharge

Cause Solution
  • Auger drive belt is loose or damaged
  • Replace belt or adjust auger control cable. See Adjust Auger Cable on page 15 or see your Ariens dealer.
  • Discharge chute is clogged with snow
  • Stop engine immediately. Clean discharge chute and auger housing. DO NOT use your hands
  • Auger paddles are worn or damaged.
  • Replace auger paddles. See Maintenance Schedule on page 12 or see your Ariens dealer.

The Ariens Crossover 932050 Auger propel system does not pull unit forward properly

Cause Solution
  • Scraper is adjusted too far down
  • Adjust scraper upward. See Adjust Scraper Blade on page 17.
  • Auger paddles are worn and need to be replaced
  • Replace auger paddles. See Replace Auger Paddles on page 16 and Adjust Scraper Blade on Page 17

Ariens Crossover 932050 Replacement Parts

How to Diagnose and Repair a Ariens Crossover 932050

This guide will help you identify and resolve issues with your Ariens Crossover 932050 Snow Blower.

Ariens Crossover 932050 Issues? Need Help?

Users are encouraged to share their tips or frustrations with their Ariens Crossover 932050 with the community by leaving a comment. Sharing insights and experiences can help other users get the most out of their snow blower and avoid common issues.

Share your Thoughts or Describe your problem below:

The maximum upload file size: 5 MB. You can upload: image. Links to YouTube, Facebook, Twitter and other services inserted in the comment text will be automatically embedded. Drop files here

Ask a Ariens Crossover 932050 Question

If you're facing a particular issue with your Ariens Crossover 932050 and need assistance, feel free to ask your question here.

Submit Question

Related Snow Blower Problems